Wolfvision VZ-C3D User Manual Uživatelský manuál stáhnout pdf (Strana 2)

Precautions

ENGLISH

Please observe the following:

Risk of electric shock

Dangerous voltage inside

WARNING!

CAUTION! INSTALLATION AND SERVICING OF THE VISUALIZER MUST BE PERFORMED BY

QUALIFIED SERVICE/INSTALLATION PERSONNEL FOLLOWING THE MANUFACTURER'S

INSTALLATION INSTRUCTIONS AND IN COMPLIANCE WITH THE NATIONAL ELECTRIC CODE,

ALL LOCAL BUILDING AND SAFETY CODES AND ALL OTHER APPLICABLE CODE PROVISIONS

OR REGULATIONS.

USE THIS UNIT ONLY WITH THE CORRECT VOLTAGE AS SHOWN ON THE TYPE LABEL !

DO NOT EXPOSE THE UNIT TO HEAT OR MOISTURE !

PROTECT THE UNIT FROM EXCESSIVE SHOCKS !

USE SECURITY ROPE TO PREVENT IT FROM FALLING DOWN !

Make sure that sufficient air circulation for cooling the unit is possible (ventilation slots on top of

the unit)!

If there is any abnormality (abnormal noise, smell, smoke etc.) disconnect the unit from mains

immediately and contact your Visualizer dealer!

Do not use a damaged power cord. This may cause short circuits or electrical shocks!

To prevent danger, do not modify the unit or operate without the cover panel firmly in place!

Do not expose the unit to water, metallic objects or any flammable material.

Avoid installing the unit in locations exposed to strong magnetic fields or electrical currents.

Avoid installing the unit in environments where there is radiation. This could cause monitor image

distortion or damage to the camera sensor.

Do not pull the plug from the power socket with wet hands!

If the unit is not used for a long time, disconnect it from mains!

Precautions for the laser pointer:

Laser light - Do not stare into beam!

Do not modify the laser! Do not view the laser beam with optical instruments!

Information for laser pointer

FDA accession number: 9912688-00

This device complies with 21 CFR 1040.10 and 1040.11

The laser beam exits the

remote control through the

smaller (left) opening on

the front.

Technical data:

λ = 635 - 680nm

P< 1mW

Θ 2mrad

This label will be found on the

underneath of the remote

control.

Precautions for LED light according EN62471:

LED lighting system - Do not stare into beam!

Do not modify the LED lighting system!

Do not view the light beam with optical instruments!

Ne pas regarder dans l'objectif lorsque le visualiseur est en marche!

CAUTION

Double pole / neutral fusing.

ATTENTION

Double pôle / fible sur le neutre

1 2 3 4 5 6 7 ... 35 36

Komentáře k této Příručce

Žádné komentáře

Wolfvision VZ-C3D User Manual Uživatelský manuál Strana 2

Komentáře k této Příručce

Související produkty a manuály pro Videokamery Wolfvision VZ-C3D User Manual